Fixed an issue with certain turning profile roughing operations with back to front direction where they were gouging into the model.Fixed an issue with certain turning profile roughing operations where setting tangential extensions to certain values was giving an internal cam error.Fixed an issue with certain turning profile roughing operations where the tool retracted incorrectly after a cutting pass.Fixed an issue in which a spiral toolpath in Pocket3D sometimes resulted in a kernel crash and no toolpath.Fixed an issue with Pocket3D in which a gouge could occur in some cases when the toolpath incorrectly duplicated passes.Fixed an issue in which Pocket2D sometimes ignored open input contours if they did not contain arcs.Fixed an issue in which Pocket2D sometimes was cutting through islands that should have been avoided.Fixed an issue in which a spiral toolpath in Pocket2D could generate a gouge in some circumstances.Fixed a performance problem that could occur in Contour2D and Pocket2D when using many stepovers.Fixed a crash that could occur in some circumstances when using Contour2D.Fixed an issue in which Contour2D toolpaths would fail to generate when using multiple depths and the top and bottom heights were equal.Fixed incorrect leads in Contour2D when 'In Control' compensation was enabled and 'Horizontal Lead Arcs' was disabled.Improved the alignment of starting positions on closed cutting passes in Blend.

Fixed an issue in which the Slot strategy could produce an incorrect toolpath when the input contour was open and had an arc at the end.Improved the stability of the Slot strategy so that it recognizes more slots and produces valid toolpaths.Fixed an issue in which offsets defining hole heights could be applied in the wrong direction.Fixed an issue in which holes could be drilled 'upside down' when using select by diameter.

Installation WHAT’S NEW The following changes have been made in the current update (2023): This document covers these Inventor CAM products: Autodesk® Inventor CAM™ 2023 Release Notes

Autodesk inventor 2015 cam